LAND ROVER FRELANDER 2 2006 Repair Manual

7.
8.
9.
Installation
To i nst all , revers e t he removal procedure.1.

Check the headlamp al ignment and adjus t if neces s ary.2.

Publi s hed: 11-May-2011
Exterior Lighting - Rear Lamp Assembly
Removal and Inst all ati on
Removal
• NOTE: Removal s t eps in t his procedure may cont ain i nst all ati on det ail s. 1. CAUTION: Take ext ra care not t o damage the
edges of the component .
T orque: 2 Nm 1.
2.
3.
NOTE: Do not dis ass embl e further if t he component
i s removed for acces s onl y.
3.

Installation
To i nst all , revers e t he removal procedure.1.

Publi s hed: 11-May-2011
Exterior Lighting - High Mounted Stoplamp
Removal and Inst all ati on
Removal
Remove t he li ft gat e upper trim panel .
Refer t o: Li ft gate Trim Panel (501-05 Interi or Trim andOrnament ati on, Removal and Ins tal lat ion).
1.
2.
3. NOTE: Do not dis ass embl e further if t he componenti s removed for acces s onl y.3.
Installation
To i nst all , revers e t he removal procedure.1.

Publi s hed: 11-May-2011
Exterior Lighting - Headlamp Switch
Removal and Inst all ati on
Removal
1. CAUTION: Prot ect t he s urroundi ng trim t o avoi ddamage.1.
Installation
To i nst all , revers e t he removal procedure.1.

Publi s hed: 11-May-2011
Exterior Lighting - Side Turn Signal Lamp
Removal and Inst all ati on
Removal 1.
Installation To i nst all , revers e t he removal procedure.
1.

Publi s hed: 11-May-2011
Exterior Lighting - Headlamp Leveling Module
Removal and Inst all ati on
Removal
• NOTE: Removal s t eps in t his procedure may cont ain i nst all ati on det ail s.
Remove t he glove compartment .
Refer t o: Glove Compart ment (501-12 Ins trument Panel and
Consol e, Removal and Ins t al lat ion).
1. T orque:
7 Nm 2.
Installation To i nst all , revers e t he removal procedure.
1.
Us ing t he Land Rover approved diagnost ic sys tem, cali brat e a new
module.
2.

Publi s hed: 11-May-2011
Exterior Lighting - Trailer Module
Removal and Inst all ati on
Removal
• NOTE: The t rail er modul e i s fi tt ed wi th a replaceble fuse.
Remove t he LH rear quart er trim panel .
Refer t o: Rear Quarter Tri m Panel (501-05 Int erior Tri m andOrnament ati on, Removal and Ins tal lat ion).
1.
Remove the trai ler module.2.
3. NOTE: Do not dis ass embl e further if t he componenti s removed for acces s onl y.
Remove t he fus e.
3.
Installation
To i nst all , revers e t he removal procedure.1.
Us ing t he Land Rover approved diagnost ic sys tem, cali brat e a newmodule.2.

Publi s hed: 11-May-2011
Exterior Lighting - Stoplamp Switch
Removal and Inst all ati on
Removal
Right-hand drive vehicles
Remove t he cover and dis connect the bat tery ground cabl e.
Refer t o: Specificati ons (414-00 Bat tery and Charging Sys tem -General Informat ion, Specificati ons).
1.
Remove t he dri ver l ower ai r bag.
Refer t o: Dri ver Lower Air Bag Module (501-20B SupplementalRes traint Sys t em, Removal and Inst all at ion).
2.
3.
All vehicles
4. CAUTION: The s wit ch has a l at ching device t hatonly al lows t he s wit ch to be removed or i ns t alled whent he s wit ch plunger i s depres sed.
• NOTE: RHD ill ust rat ion shown, LHD i s s imi lar.
4.