MITSUBISHI SPYDER 1990 Service Repair Manual

AUTOMATIC TRANSAXLE OVERHAUL
T/C clutch switch valve.
overdrive clutch.
TSB Revision

gear remover
,,
TSB Revision

AUTOMATIC TRANSAXLE Took
Tool
Removal of differential bearing
bearing cup. Adjustment of differential bearing.
Removal of transfer shaftbearing cone.
TSB Revision

AUTOMATIC TRANSAXLE OVERHAUL’ Special
Tool
cone, output bearing cone.
TSB Revision

AUTOMATIC TRANSAXLE OVERHAUL
DISASSEMBLY
Caution
Do not intermix clutch discs or plates, or might
fall.
(1) Remove oil pan bolts..
(2) Remove oil pan.
(3) Remove oil filter.
(4) Remove valve body attaching bolts (18).
TSB RevisionI

Underdrive clutch
Sealring
(6)Remove valve body.
(7) Remove underdrive clutch
clutch accumulator with and seal rings.
.
(8)Remove return spring and two rings from the
and underdrive clutch accumulator
( 9 ) R e m o v e t h e s n a p r i n g ‘ h o l d i n g t h e
accumulator plug (cover) in place.
,
,
TSB Revision

AUTOMATIC TRANSAXLE OVERHAUL Transaxle
adjustable
.
(11) Put a dab of petrolatum on the top of low/reve rse,
accumulator piston. Using a
bar or,
equivalent, press the bar evenly against the
so it sticks to the piston. Pull piston’.
two return springs.
input shaft end play before disassembly Will
usually indicate when a No. 4 thrust plate
is
required (except when major parts are
No. 4 thrust plate is the overdrive
hub.
Attach a dial indicator to transaxle its
plunger seated against end of input shaft.
Move input shaft in and out to obtain end
reading.
End play specifications are
to 0.64 mm to
inch.). Record indicator reading for reference
reassembling the. transaxle.
input speed sensor.
TSB Revision

the weights of the pullers against the
of the tools to loosen the pump. on input
while loosening pump. ,
o i l p u m p .
.
oil pump gasket.
,
,,
TSB Revision

needle bearing
washer
cooler
No. 1 caged needle
input clutches assembly.
No. 4 thrust plate and front sun gear
and pull to carrier and rear
assembly.
Remove No. 6 needle bearing.

AUTOMATIC TRANSAXLE OVERHAUL Transaxle
rear sun gear and No. 7 needle bearing.
spring compressor Using the special
tool, compress the
clutch retainer just enough to
remove the snap ring.
Using a screwdriver, remove the clutch retainer snap
ring.
up clutch retainer by hand.
clutch retainer.
clutch spring.
TSB Revision