MITSUBISHI SPYDER 1990 Service Repair Manual

AUTOMATIC TRANSAXLE OVERHAUL Transaxle
Clutchplate
TSB Revision
Low/reverse
One disc from
clutch pack.
NOTE
Tag clutch pack for reassembly identification.
,
tapered ring by prying with a
as shown.
low/reverse reaction plate.
one disc from low/reverse clutch.
a screwdriver, out the low/reverse reaction
flat snap ring.
Caution
Use care not to scratch the plate with
screwdriver tip while prying out snap ring.

low/reverse clutch pack. ,
NOTE
Tag low/reverse clutch pack for identification.
A U T O M A T I C T R A N S A X L E
rear bolts.
rear cover.
holding transfer shaft gear with Holder
loosen transfer shaft nut.
transfer shaft gearnut and lock washer.

Transfer shaft
Bearing cup retainer
Gear Puller and to
transfer shaft gear.
Using the appropriate wrench, turn, “the, center
clockwise to remove gear.
transfer shaft gear and shim.
(42) Remove bearing cap retainer.
Bearing Puller and Button
on transfer shaft gear bearing to remove bearing.
Bearing Cup Remover- 1, remove transfer
shaft gear bearing cup.

AUTOMATIC TRANSAXLE OVERHAUL Transaxle
Transfer shaft
transfer shaft ‘bearing snap
Pliers
transfer shaft with
oil baffle and bearing cup from
transfer shaft Bearing
holding output gear with
output gear bolt.
TSB Revision

TRANSAXLE OVERHAUL
output gear bolt and coned lock washer.
.
Gear Puller with Bolts and
Thrust Button to output gear. Turn puller center
bolt clockwise to remove gear.
output gear and shim.
Bearing and Gear Puller Button
on output gear bearing to remove bearing.
gear carrier assembly.
TSB Revision

AUTOMATIC TRANSAXLE OVERHAUL”-’ Transaxle
and
Low/reverse
gear carrier bearing with-, Rearing
and Button
center bolt of Spring Compressor Spring
Compressor
Disc 0 to. assemble
low/reverse spring compressor tool.
. compressor tool as shown. Compress
low/reverse piston assembly.
Position Spring Compressor to
to snap ring.
snap ring with snap ring pliers.
low/reverse. piston return spring.
TSB Revision

AUTOMATIC TRANSAXLE OVERHAUL Transaxle
out park rod bracket anchor shaft with
hammer and drift.
Drift
Park rod bracket anchor shaft
,
guide bracket shaft and plug.
out guide bracket pivot with pliers.
pivot shaft bracket.
l Guide bracket’ (assembled)
Guide
bracket
-r at c h et
TSB Revision

AUTOMATIC TRANSAXLE OVERRAUL , , ,
,Guide bracket
Split sleeve
.
Spacer
IStepped
spacer
spring
Low/reverse piston
Lip seal
Low/reverse ,, Screwdriver
retainer
screws
l
Guide bracket (disassembled)
low/reverse clutch piston.
screws low/reverse
piston retainer.
low/reverie clutch piston retainer gasket.
TSB Revision

AUTOMATIC TRANSAXLE OVERHAUL
out “output a steel
h a m m e r .
Drift bearing cup all the way,.
Remover 1.
TSB Revision

AUTOMATIC TRANSAXLE OVERHAUL Transaxle
REASSEMBLY
. . .
(1) Install both output bearing Bearing
and wrenches.
(2) Install low/reverse clutch
Be sure to align gasket holes.. .
(3) Install low/reverse clutch piston retainer.
(4) install screws attaching low/reverse clutch piston
retainer.
(5) Install low/reverse clutch piston.
TSB Revision