RENAULT KANGOO 2016 X61 / 2.G Workshop Manual
Manufacturer: RENAULT, Model Year: 2016, Model line: KANGOO, Model: RENAULT KANGOO 2016 X61 / 2.GPages: 173, PDF Size: 3.8 MB
Page 51 of 173
JauneNoirNoir texte
1.45
ENG_UD7264_1
Tableau de bord : témoins lumineux (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_1
ûSTOP light
This goes out as soon as the engine
starts. It lights up in conjunction with
other warning lights.
It requires you to stop immediately, for
your own safety, as soon as traffic con-
ditions allow. Switch off the engine and
do not restart it.
Contact an approved Dealer.
øSER vICE warning light
This comes on when the igni-
tion is switched on and goes out after
3 seconds.
It may comes on in conjunction with
other warning lights on the instrument
panel.
It means you should drive very care-
fully to an approved Dealer as soon as
possible. You risk damaging your vehi-
cle if you keep driving after this warning
light has come on.
INSTRUMENT PANEL: warning lights (4/4)
The presence and operation of the warning lights DEPEND ON THE EQUIPMENT\
AND COUNTRY.
A
ÆSerious injection fault warn-
ing light/Coolant tempera-
ture warning light
Warning light for serious injection
fault
If this light flashes when you are driv-
ing, it indicates a fault in the injection
system. Stop immediately, switch off
the ignition and contact an approved
Dealer.
Coolant temperature warning light
If this light comes on (continuously
lit) when you are driving, it indicates
engine overheating. Stop and allow
the engine to run at idle speed for a
minute or two. The temperature should
drop. If not, stop the engine. Let the
engine cool down, then check the cool-
ant level. Contact an approved Dealer
if necessary
ÐNot used
ENot used
VNot used
ùNot used
HNot used
ïNot used
ÑNot used
Page 52 of 173
1.46
ENG_UD7265_1
Tableau de bord : afficheurs et indicateurs (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_1
Jaune NoirNoir texte
Rev counter 1(scale ×100)
INSTRUMENT PANEL: display and indicators (1/2)
Speedometer 2(km or miles per hour)
12
Fuel gauge 3The number of squares lit shows the
fuel level. When it is at minimum, the
squares disappear and the low fuel
level warning light comes on.
Coolant temperature
indicator
4
Under normal use, four squares are lit.
The number of squares lit depends on
the engine coolant temperature. There
is no warning unless the last three
squares light up
34
Page 53 of 173
JauneNoirNoir texte
1.47
ENG_UD7265_1
Tableau de bord : afficheurs et indicateurs (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_1
Multifunction key 5
Depending on the vehicle, repeatedly
pressing
button 5 allows information to
be brought up on the display, the trip
mileage recorder to be reset (the trip
mileage recorder must be selected on
the display for this operation) or the
clock to be set.
–
Display selection
Press briefly to move from the total mile-
age to the trip mileage and vice versa.
–
Resetting the trip mileage recor-
der
With the display of the trip mileage re-
corder selected, press and hold the
button.
INSTRUMENT PANEL: display and indicators (2/2)
5
Low engine oil level warning
Display A informs the driver that the
engine oil level is low when the engine
is started. This warning lasts for 30 sec-
onds. Refer to the information on the
“Engine oil level” in Section 4.
A
Page 54 of 173
clock ..................................................... (up to the end of the DU)
clock ..................................................... (up to the end of the DU)
1.48
ENG_UD7267_1
Heure (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_1
Clock
If the electrical supply is cut (battery
disconnected, broken supply wire,
etc.), the clock will lose its time set-
ting. The clock must be reset.
CLOCK
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
Clock 1
Resetting the clock
With the ignition on , and display 1
set to total mileage recorder and clock,
p
ress and hold button 2 , to access
“clock setting” mode (clock flashes)
then release the button.
–
Pressing and holding button 2 allows
you to scroll through the hours and
minutes quickly;
–
short presses on button 2 allow you
to set the time minute by minute.
1
2
Page 55 of 173
headlight beam adjustment .................. (up to the end of the DU) 1.49
ENG_UD7270_1
Réglage électrique de la hauteur des faisceaux (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_1
Headlight beam adjustment
ELECTRICAL ADJUSTMENT OF THE DIPPED BEAM HEADLIGHTS
Control knob A is used to adjust the
height of the headlight beams accord-
ing to the load.
T
urn control knob A to the left to lower
the headlights and to the right to raise
them.
Load status Examples of positions for adjusting
control A according to the load.
Driver only or with passenger 0
All seats occupied 1
Intermediate position
According to driver’s judgement 2
Driver only with luggage compartment
laden
(1)3
Increased payload version: 4
All seats occupied with luggage com-
partment loaded
(1)4
(1) Load status at maximum permitted weight.
A
Page 56 of 173
lights-on warning buzzer........................................ (current page)
signals and lights .................................. (up to the end of the DU)
1.50
ENG_UD14260_2
Éclairage et signalisation extérieure (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_1
Jaune NoirNoir texte
External lighting and signals
oMain beam headlights
With stalk 1 in dipped beam
headlights position, move the stalk to-
wards you.
When the main beam headlights are lit,
an indicator light lights up on the instru-
ment panel.
To return to the dipped beam headlight
position, pull the stalk towards you.
uSide lights
Turn the end of stalk 1 until the
symbol is opposite mark
2.
mDipped beam
headlights
Turn the end of stalk 1 until the symbol
is opposite mark
2.
An indicator light on the instrument
panel comes on.
EXTERNAL LIGHTING AND SIGNALS (1/2)
12
Before driving at night,
check that the electrical
equipment is operating cor-
rectly and adjust the head-
light beams (if your vehicle is not
carrying its normal load). As a gen-
eral precaution, check that the lights
are not obscured (by dirt, mud, snow
or objects being transported).If the vehicle is parked on
the hard shoulder with tail-
gate open, the rear lights
may be obscured. You
should make other road users aware
of your vehicle by using a warning
triangle or other equipment speci-
fied by the road traffic regulations of
the country you are driving in.
Page 57 of 173
JauneNoirNoir texte
1.51
ENG_UD14260_2
Éclairage et signalisation extérieure (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_1
fRear fog light
Turn the centre ring of stalk 1
until the symbol is opposite mark
3.
Operation of the fog lights depends on
the exterior lighting selected, and an in-
dicator light will light up on the instru-
ment panel.
To avoid inconveniencing other road
users, remember to switch off the rear
fog light when it is no longer needed.
Note: when the exterior lights are
switched off, the rear fog light is
switched off or the control returns to
the front fog lights position (if these are
fitted on the vehicle).
gFront fog lights
Turn the centre ring of stalk 1
until the symbol is opposite mark
3.
Operation of the fog lights depends on
the exterior lighting selected, and an in-
dicator light will light up on the instru-
ment panel.
EXTERNAL LIGHTING AND SIGNALS (2/2)
13
eSwitching off the lights
Bring stalk 1 back to the zero position.
Lights-on warning buzzer
A warning buzzer will sound when the
driver’s door is opened and the lights
have been left switched on after the ig-
nition has been switched off (to prevent
discharge of the battery).
Page 58 of 173
windscreen washer ............................... (up to the end of the DU)
wipers ................................................... (up to the end of the DU)
1.52
ENG_UD7272_1
Essuie-vitre / lave-vitre avant (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_1
Special note
When the vehicle is being driven,
the wiping speed slows down when-
ever the vehicle stops. The speed will
change from fast wipe speed to normal
wipe speed.
As soon as the vehicle moves off,
wiping will return to the speed originally
selected.
A
ny action on stalk 1 overrides and
cancels automatic operation.
sWindscreen washer
With the ignition on, pull stalk 1 towards
you.
A short press triggers one sweep cycle
of the wiper.
A longer press triggers four sweeps fol-
lowed by a final sweep after several
seconds.
Windscreen washer/wiper
nWindscreen wiper
With the ignition on, move stalk 1
around the steering wheel:
A park
B intermittent wiping
The wipers will pause for several
seconds between sweeps.
C normal wiping speed
D fast wiping speed
WINDSCREEN WASH/WIPE
A
B
C
D
1
In freezing or snowy weather, ensure
they are not stuck to the windscreen
(including the central area located
behind the interior rear-view mirror)
and the rear screen before starting
the wipers (risk of motor overheat-
ing).Before any action on the
windscreen (washing the
vehicle, de-icing, cleaning
the windscreen, etc.) return
stalk
1 to position A (park).
Risk of injury and/or damage.
Page 59 of 173
wipers ................................................... (up to the end of the DU)
windscreen washer ............................... (up to the end of the DU) 1.53
ENG_UD7273_1
Essuie-vitre / Lave-vitre arrière (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_1
pRear screen wash/wipe
With the ignition on, turn the
e
nd of stalk 1 to align the symbol with
mark
2.
When the stalk is released, it returns to
the rear screen wiper position.
YRear screen wiper with
timer
With the ignition on, turn the end of
stalk
1 to align the symbol with mark 2.
REAR SCREEN WASH/WIPE
1
2
Check the condition of the wiper
blades. You are responsible for their
service life:
–
they must remain clean: clean
the blades, windscreen and
rear screen regularly with soapy
water;
–
do not use them when the wind -
screen or rear screen are dry;
–
free them from the windscreen or
rear screen when they have not
been used for a long time.
In all cases, replace them as soon
as they begin to lose efficiency: ap-
proximately once a year.
Before using the rear wiper, check
that no object obstructs the travel of
the blade.
Do not use the wiper arm to open or
close the tailgate.
Page 60 of 173
fuel filler cap ......................................... (up to the end of the DU)
fuel tank capacity .................................. (up to the end of the DU)
fuel tank capacity ........................................... (up to the end of the DU)
1.54
ENG_UD14016_2
Réservoir carburant (X76 - Renault)
ENG_NU_854-2_X76LL_Renault_1
Jaune NoirNoir texte
Fuel grade
Use a high grade fuel that complies
with the standards currently in force in
each country.
Petrol versions
It is essential to use unleaded petrol.
Depending on the vehicle, the octane
rating (RON) must comply with the in-
formation on the label located beside
the filler neck.
Refer to the information on “Engine
specifications” in Section 6.
Diesel versions
It is essential to use diesel fuel that
complies with the information given on
the label beside the filler neck.
Make sure that no water accidentally
enters the fuel tank during filling. The
shut-off system and its surrounding
area must be dust-free.
Capacity of the fuel tank: 50 litres
ap-
proximately.
Fuel tank
Do not mix even small vol-
umes of petrol with diesel
Do not use ethanol-based
fuel if your vehicle is not
compatible with this fuel.
Fuel filler cap: this is spe-
cific to the vehicle type.
If you have to replace it,
make sure it is identical to
the original cap. Contact your ap-
proved Dealer.
Never place the cap near a source
of heat or flame.
Do not wash the filler area with a
high-pressure washer.
FUEL TANK (1/2)
As a safety measure, the sliding side
door located on the fuel filler flap
side locks when the flap is opened.
For more information, refer to the in-
formation on “Central door locking/
unlocking” in Section 1.