JAGUAR XFR 2010 1.G Workshop Manual

12.
Refer to: Crankshaft Pulley (303-01D Engine - V8 S/C 5.0L Petrol, Removal and Installation).

13. Refer to: Valve Cover RH (303-01D Engine - V8 S/C 5.0L Petrol, Removal and Installation).

14. Refer to: Valve Cover LH (303-01D Engine - V8 S/C 5.0L Petrol, Removal and Installation).

15. Refer to: Thermostat Housing - Vehicles With: Supercharger (303-03C Engine Cooling - V8 5.0L Petrol/V8 S/C 5.0L Petrol, Removal and
Installation).

16. Refer to: Accessory Drive Belt Tensioner (303-05D Accessory Drive - V8 S/C 5.0L Petrol, Removal and Installation).

17. Refer to: Accessory Drive Belt (303-05D Accessory Drive - V8 S/C 5.0L Petrol, Removal and Installation).

18. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). www.JagDocs.com

Engine - V8 S/C 5.0L Petrol - Timing Drive Components
Removal and Installation

Special Tool(s)


303-1445
Timing Tool – Camshaft Alignment

303-1447
Timing Tool

303-1448
Locking Tool

303-1452
Camshaft Rotating Tool

303-1482
Tensioner Tool Removal


CAUTION: Check all timing components for wear and install new components if required.
NOTES:


Removal steps in this procedure may contain installation details. Published: 12-Jun-2014

Some variation in the illustrations may occur, but the essential information is always correct.

1. Disconnect the battery ground cable.

Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).


2. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.

3. Refer to: Timing Cover (303-01C Engine - V8 5.0L Petrol, Removal and Installation).

4.
5. CAUTION: Only rotate the crankshaft clockwise.
Install the special tool.

Special Tool(s): 303-1447

6. CAUTION: If the noted postion of the woodruff key is
at the 9 o'clock position, then a new flexplate must be
installed. If the woodruff key is in the 6 o'clock position
then proceed with the next step.
Note the position of the crankshaft woodruff key.





























7.

10.


































11. CAUTION: If the variable valve timing (VVT) units are
knocked or dropped then the VVT must be replaced.
Remove the timing chain with the VVT units. www.JagDocs.com

14.


































15. CAUTION: If the VVT is knocked or dropped then the
VVT must be replaced.
Remove the timing chain with the VVT units.

Installation
16.
CAUTION: Discard the friction washer.


1. CAUTION: Install a new friction washer.

2. Torque: 12 Nm 3.
Install the special tool to each Camshaft.
Special Tool(s): 303-1452 Torque: 10 Nm













4.
Carefully rotate the camshafts if the position is not
as shown.