JAGUAR XFR 2010 1.G Workshop Manual

23.
24. Drill out the spot welds as indicated.


























NOTE: Care should be taken not to cause damage to
remaining panels when separating joints containing
adhesive.

Separate the joints and remove the old panel, observing
the areas of NVH component and adhesive as indicated.















Installation

1. Offer up the new panel and clamp into position. Check alignment, if
correct, proceed to next step, if not rectify and recheck before
proceeding.

10.























11. NOTE: Make sure the adhesive does not encroach into
the areas of the MAG plug welds as it will contaminate the
weld.
Apply adhesive to the area as indicated.




















Apply adhesive to the area as indicated. www.JagDocs.com

15.























16. NOTE: Spot welds must be installed 5mm away from
the originals and in the same quantities, whenever this is
possible. Where this is not possible spot welds should be
installed adjacent to the original. Where there is adhesive
in the original joint, spot welds should be installed through
the original.
Spot weld.

















MAG plug weld.

Side Panel Sheet Metal Repairs - B-Pillar Inner Panel
Removal and Installation

Removal Published: 11-May-2011


1. NOTE: The B-pillar inner panel is manufactured from mild
steel.

The B-pillar inner panel is cut from the bodyside inner front
section service panel.
















2. The B-pillar inner panel is replaced in conjunction with:
Front door
Rear door
Rocker panel and B-pillar outer panel
B-pillar reinforcement
Rocker panel inner reinforcement
Headliner

3. For additional information relating to this repair procedure please see
the following:
For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operation) /
Body Repairs (501-25A Body Repairs - General Information, Description and Operation) /
Corrosion Protection (501-25B Body Repairs - Corrosion Protection, Description and Operation) /
Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).

4. Remove the rocker panel inner reinforcement.
For additional information, refer to: Rocker Panel Inner Reinforcement (501-29 Side Panel Sheet Metal Repairs, Removal and Installation). www.JagDocs.com