SSANGYONG KORANDO 1997 Service Repair Manual

SSANGYONG MY2002
9G-2 INTERIOR TRIM
DESCRIPTION AND OPERATION
INTERIOR TRIM PANELS
The interior trim panels are molded plastic and fasten
with screws or plastic clips.
FLOOR CARPET
The floor carpets are divided front and rear floor carpet.
FLOOR CONSOLE
The floor console fits over the tunnel in the floor of the
vehicle and extends from under the center of the
instrument panel to the rear seat area. The floor console
contains the transaxle shift lever, parking brake lever,
a storage compartment and coin storage

INTERIOR TRIM 9G-3
SSANGYONG MY2002
COMPONENTS LOCATOR
INTERIOR TRIM
1 Console Box
2 Tray
3 Arm Rest
4 Parking Lever Strip
5 Facia (BTRA A/T)
6 Indicator Cover7 Facia (M/T)
8 Boot Assembly (M/T)
9 Facia (MB A/T)
10 Rear Facia Strip
11 Rear Facia Cap
KAA9G010

SSANGYONG MY2002
9G-4 INTERIOR TRIM



yyyy yyyy
yyyy
yyyy
KAA9G030
KAA9G040
3. Remove the power window control switch.
4. Disconnect the power window control switch
electrical connector.
5. Remove the door trim panel screws.
KAA9G020
ON-VEHICLE SERVICE
UNIT REPAIR
DOOR TRIM PANEL
Removal and Installation Procedure
1. Lower the window.
2. Pry off the inside door handle trim bezel.
REPAIR INSTRUCTIONS

INTERIOR TRIM 9G-5
SSANGYONG MY2002
EF
KAA9G060
KAA9G050
A-PILLAR TRIM PANEL
Removal and Installation Procedure
1. Remove the roof assist handle with the screws.
2. Remove the A-pillar trim panel.
3. Installation should follow the removal procedure
in the reverse order. 6. Disconnect the electrical connector.
7. Remove the door trim panel.
8. Installation should follow the removal procedure
in the reverse order.
KAA9G080
KAA9G070
3. Remove the upper quarter trim panel.
4. Installation should follow the removal procedure
in the reverse order.
UPPER QUARTER TRIM PANEL
Removal and Installation Procedure
1. Remove the roof assist handle with the screws.
2. Remove the seat belt anchor with the bolt.
Installation Notice
•Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use
the correct fasteners to prevent premature
corrosion.
Tightening Torque 45 Nm (33 lb-ft)

SSANGYONG MY2002
9G-6 INTERIOR TRIM


y y
y
KAA9G100
KAA9G090
2. Remove the armrest. Refer to Section 9H “SEATS”.
3. Remove the ashtray and compartment lamp from
lower quarter trim panel.
4. Remove the roof rear trim and back panel cover.
LOWER QUARTER TRIM PANEL
Removal and Installation Procedure
1. Lift up the rear seat from the floor.
KAA9G120
KAA9G110
COWL SIDE TRIM PANEL
Removal and Installation Procedure
1. Remove the cowl side trim panel. Refer to front
rocker trim panel in this section.
2. Remove the cowl side trim panel with the screws.
3. Installation should follow the removal procedure
in the reverse order. 5. Remove the lower quarter trim panel with the
screws.
6. Installation should follow the removal procedure
in the reverse order.

INTERIOR TRIM 9G-7
SSANGYONG MY2002
KAA9G140
KAA9G130
FLOOR CONSOLE
Removal and Installation Procedure
1. Remove the screws.
2. Remove the floor console.
3. Disconnect the electrical connector.
4. Installation should follow the removal procedure
in the reverse order.
FRONT ROCKER TRIM PANEL
Removal and Installation Procedure
1. Remove the screws.
2. Remove the rocker trim panel.
3. Installation should follow the removal procedure
in the reverse order.
KAA9G160
KAA9G150
6. Remove the luggage hook with the mounting
screws.
7. Remove the front seat. Refer to Section 9H, Seats.
FLOOR CARPET
Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Remove the rear seat. Refer to Section 9H, Seats.
3. Remove the bolts and the left and the right lower
seat belt anchors.
4. Remove the child seat anchor. Refer to Section
9H, Seats.
5. Remove the floor carpet screws.

SSANGYONG MY2002
9G-8 INTERIOR TRIM
KAA9G170
8. Remove the kick panel. Refer to “Kick Panel” in
this section.
9. Remove the lower quarter trim panel. Refer to
“Lower Quarter Trim Panel” in this section.
10. Remove the front floor carpet.
11. Installation should follow the removal procedure
in the reverse order.

INTERIOR TRIM 9G-9
SSANGYONG MY2002
Seat Belt Anchor BoltApplication N•m
Lb-FtLb-In
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
45 33 -

SECTION 9H
SEATS
TABLE OF CONTENTS
Components Locator............................................9H-2
Seats ...................................................................9H-2
Repair Instructions................................................9H-3
On-Vehicle Service Unit Repair................................9H-3
Front Seat............................................................9H-3
Front Seat Cushion..............................................9H-3
Front Seatback....................................................9H-4
Front Seat Guide Rail ...........................................9H-4
Front Seat Recliner Lever.....................................9H-5
Front Seat Trim....................................................9H-5
Head Restraint.....................................................9H-5Walk In Device....................................................9H-6
Front Seat Armrest...............................................9H-6
Rear Seat Armrest ...............................................9H-6
Rear Seat............................................................9H-7
50/50 Split Rear Seat Cushion Hinge....................9H-7
50/50 Split Rear Seat Cushion Lock Striker...........9H-8
Child Seat Anchorage ..........................................9H-8
Specifications.......................................................9H-9
Fastener Tightening Specifications.......................9H-9
Schematic and Routing Diagram......................9H-10
Seat Heater.......................................................9H-10

SSANGYONG MY2002
9H-2 SEATS
COMPONENTS LOCATOR
SEATS
1 Seat A-FRT
2 Seat A-FRT
3 Head Rest Sleeve A
4 Head Rest A-FRT
5 Shield Cover
6 Bolt-Hex SEMS
7 G/Rail A-FRT
8 Recliner A-FRT
9 Lumber Support-Knob10 Seat-RR
11 Seat-RR
12 Arm Rest A-RR
13 Striker-RR Seat
14 Head Rest A-RR
15 Head Rest Sleeve A
16 Bolt-Hex SEMS
17 Bolt-Hex SEMS
KAA9H010