CHRYSLER VOYAGER 1996 Workshop Manual

CHRYSLER VOYAGER 1996 Workshop Manual VOYAGER 1996 CHRYSLER CHRYSLER https://www.carmanualsonline.info/img/25/56867/w960_56867-0.png CHRYSLER VOYAGER 1996 Workshop Manual
Trending: checking oil, Security, set clock, towing, flat tire, jack points, length

Page 41 of 1938

CHRYSLER VOYAGER 1996 Workshop Manual FRONT SUSPENSION
INDEX
page page
DESCRIPTION AND OPERATION
BALL JOINT............................ 11
COIL SPRING........................... 11
FRONT SUSPENSION DESCRIPTION......... 9
HUB AND BEARING A

Page 42 of 1938

CHRYSLER VOYAGER 1996 Workshop Manual Mc PHERSON STRUT ASSEMBLY
The front suspension of the vehicle is supported by
coil springs positioned around the strut assembly.
The springs are contained between an upper seat,
located just below the

Page 43 of 1938

CHRYSLER VOYAGER 1996 Workshop Manual COIL SPRING
Coil springs are rated separately for each corner or
side of the vehicle depending on optional equipment
and type of vehicle service. During service procedures
when both springs are remove

Page 44 of 1938

CHRYSLER VOYAGER 1996 Workshop Manual STEERING KNUCKLE
The front suspension knuckle is not a repairable
component of the vehicles front suspensionIT MUST
BE REPLACED.If bent, broken or damaged in any
way, do not attempt to straighten or r

Page 45 of 1938

CHRYSLER VOYAGER 1996 Workshop Manual instructions included with the thread insert for the
detailed procedure used for the installation of the
thread insert.
NOTE: The thread inserts for this application are
for the repair of M8x1.25 and

Page 46 of 1938

CHRYSLER VOYAGER 1996 Workshop Manual CAUTION: The steering knuckle to strut assembly
attaching bolts are serrated and must not be turned
during installation. Install nuts while holding bolts
stationary in the steering knuckles.
(2) Align

Page 47 of 1938

CHRYSLER VOYAGER 1996 Workshop Manual CAUTION: Wheel bearing damage will result if after
loosening hub nut, vehicle is rolled on the ground
or the weight of the vehicle is allowed to be sup-
ported by the tires.
(5) With the vehicles bra

Page 48 of 1938

CHRYSLER VOYAGER 1996 Workshop Manual (9) Remove the brake rotor from the hub and bear-
ing assembly (Fig. 16).
(10) Remove nut attaching outer tie rod end to
steering knuckle (Fig. 17).Nut is to be removed
from tie rod end using the foll

Page 49 of 1938

CHRYSLER VOYAGER 1996 Workshop Manual (14) Remove the steering knuckle to ball joint
stud, clamping nut and bolt (Fig. 21) from the steer-
ing knuckle.
(15) Using a pry bar, separate steering knuckle
from ball joint stud (Fig. 22).Note: U

Page 50 of 1938

CHRYSLER VOYAGER 1996 Workshop Manual CAUTION: If the vehicle being serviced is
equipped with eccentric strut assembly attaching
bolts, the eccentric bolt must be installed in the
bottom (slotted) hole on the strut clevis bracket
(Fig. 25
Trending: OBD port, reset, check transmission fluid, battery, instrument cluster, child lock, length