reverse KIA CARNIVAL 2007 Workshop Manual

SEAT BACK FRAME REPLACEMENT
1.Remove the following items.
a. Recliner cover.
b. Seat back panel.
c. Headrest guide.
d. Seat back cover.
2. Remove the pad (A) from frame (B).
a.Remove the side air bag for replacing side air bag installation seat.
b. Be fore service, be fully aware of precautions and service procedure relevant to air bag (See page RT -
Airbag).
3.Installation is the reverse of removal.
SEAT TRACK REPLACEMENT
1.Remove the recliner cover.
2. Remove the seat cushion cover.
3. Remove the seat track (A).

4.Installation is the reverse of removal.
SEAT BACK HEATER REPLACEMENT
1.Remove the seat back cover.
2. Cut the heater (A) attached to the pad (B), as shown in the picture.
3. Take off the paper from the backside of the heater assembly.
4. Attach the heater to the main part of pad.
5. Install the seat back cover.
SEAT CUSHION HEATER REPLACEMENT
1.Remove the seat back cover.
2. Cut the heater (A) attached to the pad (B), as shown in the picture.
3. Take off the paper from the backside of the heater assembly.
4. Attach the heater to the main part of pad.
5. Install the seat back cover.

5.Remove the hog- ring clips (A).
6.Remove the headrest and headrest guide.
7. After removing the hog- ring clips (A) on the front of seat back remove the seat back cover (B).
8.Installation is the reverse of removal.
a.To prevent wrinkles, make sure the material is stretched evenly over the cover (A) before securing the
hogring clips (B)
b. Replace the hogring clips with new ones using special tool (C).

9.After removing the hog- ring clips (A) on the front of seat back remove the back cover (B).
10. Installation is the reverse of removal.
a. To prevent wrinkles, make sure the material is stretched evenly over the cover (A) before securing the hogring
clips (B).
b. Replace the hogring clips with new ones using special tool (C).
THIRD SEAT
SEAT ASSEMBLY REPLACEMENT
1.Remove the cover (A).
2.Loosen the mounting bolt.

3.Remove the seat assembly (A).
4.Installation is the reverse of removal.
RECLINER COVER REPLACEMENT
1.Remove the recliner cover (A).

2.Installation is the reverse of removal.
SEAT BACK COVER REPLACEMENT
1.Remove the recliner cable (A).
2.Loosen the mounting bolts, then remove the seat back assembly (A).
3.Remove the back panel (A).

7.After removing the hog- ring clips (A) on the front of seat back remove the seat back cover (B).
8.Installation is the reverse of removal.
SEAT CUSHION COVER REPLACEMENT
1.Remove the seat assembly.
2. Remove the recliner cover.
3. Loosen the mounting bolts, then remove the seat back assembly (A).
4.Disconnect the protector (A) from the back frame.

5.Disconnect the seat pad (B) from the back frame (A).
6.After removing the hog- ring clips (A) on the front of seat back remove the seat back cover (B).
7.Installation is the reverse of removal.
SEAT FRAME ASSEMBLY REPLACEMENT
1.Remove the cushion cover(A).

2.Installation is the reverse of removal.
SEAT BACK FRAM REPLACEMENT
1.Remove seat back cover(A).
2.Installation is the reverse of removal.

7.Installation is the reverse of removal.
SECONDARY SEAT BELT REPLACEMENT
a.When installing the belt, make sure not to damage the pretensioner.
1. Remove the following items first.
a. Rear seat assembly.
b. Front and rear door scuff trim.
c. Rear filler trim.
2. Remove the lower anchor (A).