Rear-view camera*7-68 Starting and driving
7
When you place the select position is the “R”position with the operation mode in ON, theview behind the vehicle will automaticallyappear on the screen of the Mitsubishi MultiCommunication System (MMCS) or the DIS-PLAY AUDIO. When you move the selectorlever to any other position, the screen willreturn to its original indication.
Reference lines and upper surface of the rearbumper (A) are displayed on the screen. zRed line (B) indicates approximately 50cm behind the rear bumper. zTw o G r e e n l i n e s ( C ) i n d i c a t e a p p r o x i -mately 20 cm outside of the vehicle body. zShort transverse lines (1 to 3) indicate dis-tance from the rear bumper.
How to use the rear-view cam-era
CAUTION zThe rear-view camera has a special lens thatcan make objects show
n on the screen appear
to be closer or further away than they actu-ally are.
NOTE
zBecause the rear-view camera has a speciallens, the lines on the
ground between parking
spaces may not look parallel on the screen. zIn the following situations, the screen indica-tion may be difficult to see. There is noabnormality.•Low light (nighttime)•When the light of the sun or the light from avehicle’s headlamps shin
es directly into the
lens
zIf the camera is hot and is then cooled byrain or a car wash, the lens can mist up. Thisphenomenon does not i
ndicate a malfunc-
tion. zIt is not possible to
fully see obstacles when
the lens is dirty. If the lens becomes contami-nated by water droplets, snow, mud, or oil,wipe off the contamination, taking care notto scratch the lens. zPlease observe the following cautions. Ignor-ing them could lead to a camera malfunction.•Do not subject the camera to physicalshock.•Do not apply wax to the camera.•Do not splash the camera with boilingwater.•Do not disassemble the camera.
Reference lines on the screen
1: Approximately at the rear edge of the
rear bumper
2: Approximately 100 cm3: Approximately 200 cm
BK0203201EN.book 68 ページ 2013年11月19日 火曜日 午前11時50分